Festool Plunge Router I Manuel d'utilisateur télécharger pdf (Page 21)

Edge Guide

The edge guide is used for guiding the router relative to the

edge of a workpiece. This can be used for interior plunge

rou ile

Edg

ting (such as fluted columns) or for edge forming. Wh

t e operations are similar, there are additional setups

ecessary for edge form routing.

e Forming Setup

When using the edge guide for edge forming, the router

bit

to the ri

► The tw

clear

► There are two options for dust collection. The standard

dust extraction hood may be used (see page 9), or the

optional dust chute may be attached to the underside of

the edge guide. (Both dust extraction options may be

used together, but the results may not be as expected.)

1. Loosen the four mounting screws on the fence plates

and slide the plates apart enough to clear the router

bit.

2. Retighten the mounting screws.

3. If desired, slide the dust chute under the mounting

tabs until it clicks into place.

will be within the cutout of the edge guide (as shown

ght).

o fence plates need to be separated enough to

the router bit so the bit does not cut the fence.

General Setup

The same general setup is used for both interior and

edge form routing. The image to the right shows an

interior routing setup.

1. Insert the guide rods through the edge guide as

shown, and tighten the clamping thumbscrews.

2. Insert the other end of the guide rods through the

eyelets in the router base.

3. Set the approximate position of the router, and

tighten the clamping thumbscrew on the router

base.

4. To set the final position of the router using the

micro-adjust feature:

a. Loosen the micro-adjust clamping knob on

the edge guide.

b. Turn the micro-adjustment dial to set the

position of the router.

► Turning the dial toward increasing numbers

moves the router away from the edge guide.

► Each number represents 0.1 mm, and a full

revolution is equal to 1.0 mm.

c. Retighten the clamping knob.

5. Make sure you operate the router from left to

right to keep the edge guide tight to the

workpiece. (Refer to the discussion on "Plough

Cuts" on page 13.)

Instruction Manual 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Commentaires sur ces manuels

Pas de commentaire

Festool Plunge Router I Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Festool Plunge Router I