Festool Plunge Router I Manuel d'utilisateur télécharger pdf (Page 26)

26 OF 1400 EQ Router

r Brushes Changing the Moto

The motor brushes wear out over time and need to be replaced by an authorized service center. Festool does not condone

brush replacement by the end-user.

Completion of this procedure by an unauthorized service center will void the tool's

warranty.

Removal Procedure

CAUTION! Make sure the

power cord is unplugged

before beginning this

procedure.

1. Remove the four screws that

secure the access cover to the

motor, and remove the cover.

2. Remove the three screws that

secure the upper cover to the

main handle, and remove the

cover.

3. To access one of the two brushes,

you will need to remove the

electronics module.

a. Make note where the wires

are routed.

lift up on the

il it is free

do not remove it

completely.

b. Very carefully,

copper strap unt

from the retaining tab.

c. Slide the electronics module

up, but

4. Lift the wire connectors off the terminals on the

brushes.

5. Remove the screw that secures each brush to the

motor housing. Be careful not to drop the screws

into the motor.

6. Carefully lift the brushes straight up to remove

them.

1 2 ... 21 22 23 24 25 26 27

Pas de commentaire

Festool Plunge Router I Manuel d'utilisateur Page 26